Audio Amplifier | Integrated |
Sound Synthesis Method | Wavetable |
| ES 1371 ES 1370 ES 1373 The Sound Blaster Ensoniq AudioPCI cards are based on a variety of Ensoniq chips, for example, ES1371, ES1370 and ES1373. If the chips are built on the motherboard, the best source of support for drivers and specifications would be the system vendor.
|
| Frequency Response: 30Hz - 20KHz (Line-out) Signal to Noise Ratio: 90 db Total Harmonic Distortion 1 Vrms (10 KOhm load): 0.01% Sampling Rate for Playback/Recording (Stereo): 4 KHz - 48 KHz Supply Voltage Requirement (Loading): +5, +12, -12 Volt Current Consumption (Typical): 250, 500, 50 mA respectively Microphone Impedance: 600 Ohms Line-In Impedance: 47 KOhms CD Audio-In Impedance: 50 KOhms Microphone Sensitivity: 10 - 200 mVpp Line-In Sensitivity: 0 - 2 Vpp CD Audio-In Sensitivity: 0 - 2 Vpp AD/DA Resolution: 16 bits
|
| Environment Temperature (non-operating): -40C to 70C Environment Temperature (operating): 10C to 50C Relative Humidity (non-operating): 30% to 95% Relative Humidity (operating): 30% to 80% MTBF: >60,000 hours Drop Test: 30cm above concrete ground on all 6 sides Vibration: Sine wave for X, Y and Z axis (non-operating) 5Hz to 15Hz : 0.76mm (P-P) 15Hz to 25Hz : 1.5G 25Hz to 50Hz : 0.15mm (P-P) 50Hz to 100Hz : 3G
|
| Line-In Microphone-In Line-Out (Front) MIDI/Joystick Port CD-ROM Audio-In Internal TAD Connector Internal TV Tuner Connector |
| Intel Pentium class 133MHz or faster processor Intel or 100% compatible motherboard chipset 16MB system RAM (32MB strongly recommended) Windows 95, Windows 98 or Windows NT 4.0 Open half-length PCI 2.1 compliant slot Headphones or amplified speakers (available separately) CD-ROM drive required for software installation Usage of this product in Windows NT 4.0 requires a minimum 200MHz processor and 32MB system RAM. Functionality may differ from box specifications due to limitations in Windows NT. Bundled application and utility software may have higher system requirements
|
No comments:
Post a Comment